telemut

Remote Terminal Unit

ERTU - 09A1 (Dengan Kabel)

SHINGSUNG

SS - BCB - PO

SHINGSUNG

CPU - Board

SHINGSUNG

L6 - PIB - P10

SHINGSUNG

DCM Board

CJS

LBS/Recloser

Remote Terminal Unit

SHINSUNG

IGBT - Board

IGBT board berfunfsi untuk mengontrol tegangan ke koil open dan close (IGBT board ini untuk 1 recloser pakai 2 buah, 1 untuk close dan 1 untuk close

SHINSUNG

SCAM - Board

Scam board adalah protection board yg ada didalam tank cb, itu berfungsi untuk memberikan status cb, pembacaan arus dan tegangan.

EMT

ON OFF LBS CONTROL UNIT

• Open dan Close Operation
• Load current monitoring

EMT

Motorize LBS - Remote Control Unit

• Voltage, Current, and Phase Angle
• Six voltage inputs
• Fault Passage Indication
• Over/under Voltage
• Phase Sync Fail Detection
• Harmonics (up to 31st)
• Battery charging and status monitoring
• Auto Sectionalizing

SHINSUNG

LBS – Control  Unit Scada System

Main Protection Function

• Fault indication
• Phase fault / ground fault
• Permanent fault / temporary fault
• Open conductor / loss of phase protection
• Phase synchronization failure detection
• Sectionalizer function
• SEF, HIF protection
• Voltage-current-time controlled protection coordination(VIT)
• Inrush current restraint
• DNP 3.0 / IEC 101 / IEC 104 communication protocol

SHINSUNG

Recloser – Control Unit Scada System

• Conventional function
• OCR, OCGR, SEF
• Conventional recloser curve, IEC and US curve
• High current trip, lock-out
• Cold load pick up
• Sequence coordination
• SEF (Sensitive Earth Fault)
• Under frequency load shedding
• Circuit breaker Wear monitoring
• Sequential events record and fault event report

EMT

3 Way LBS – Control Unit

3 Way LBS Merupakan fungsi gabungan 2 (dua) unit Load Break Switch, dengan skim operasi 1 incoming dan 2 out going.

EMT

FAI LBS – Control Unit

200 , 400 , 630 A

Performance FAI dimana gangguan dibawah 1 kA (Earth Fault) akan buka secara otomatis dan Re-Close secara otomatis pula. Gangguan diatas 1 kA Phase to Phase Fault, FAI tidak buka tetapi pada saat CB/Recloser di Up-Stream buka, akan bekerja ikut terbuka, setelah CB/Recloser Re-Close, jaringan setelah FAI yang menyebabkan terbukanya CB/Recloser akan diluar sistem.

G&W

LBS - Control UnitF

TUP-200

• Voltage, Current, and Phase Angle
• Six voltage inputs
• Fault Passage Indication
• Over/under Voltage
• Phase Sync Fail Detection
• Harmonics (up to 31st)
• Battery charging and status monitoring
• Auto Sectionalizing

G&W

Recloser - Control Unit

SEL – 351R

• Minimum trip for phase, ground and sensitive ground faults.
• Numerous preprogrammed and user-defined time current curves for sensing phase    or ground faults.
• Three independent recloser interval times. Capable of up to four shots to lockout.
• Reset time.
• Sequence coordination.
• DNP 3.0 Protocol.

VANWIN

Transformer Over -Load Annunciator

• Operational temperature : -25~50
• Acceptable error range : less than ±5% of the loaz value calculated using each transformer capacity(10, 15, 20, 30, 50, 75, and 100kVA) and secondary circuit voltage(110V, 220V) value
• At or above 80% of transformer load for over 5 minutes, red light turns on and the buzzer sounds.
• Sound-level of signal: approx. 85±5dB (simple sound or complex sound with multi-tone)

EMT

3 Way ALTS – Controller

ALTS Controlller

• Automatic Transfer to Alternative Distribution Line
• Compulsory Transfer to Alternative Feeder Line
• Two High Voltage Primary Feeder Alternative operation
• Programmable of Automatic Transfer Time

EMT

Smart FID System

Recieve Sending Unit

Fungsi :

• Load current memonitor
• Fault event
• SCADA system
• IEC 101 / DNP Protokol
• Alarm
• LED light